The NanoHARD is a multifunctional programmable AEG Controller with 8 functions. Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C) and comes with Battery protection support for: Li-Po 7.4V / 11.1V / 14.8V
The NanoHARD Features:
Circuit Protection - That’s why the unit has thermal protection. In tandem with a time-lag fuse, it fully protects your AEG.
Digital Interface Debouncing Feature which provides full compatibility with the micro-switches. It is fully resistant to contact bounce. This can mean you see an increased ROF, faster trigger response and your MOSFET is subject to less heat stress.
Built-in Active Brake system which also protects contacts against excessive wear. In SEMI Mode, the brake does not allow for compressing a piston after a shot. The piston will stop in the front position which eliminates unnecessary stresses, increasing the service life of the gearbox. This is an Ideal feature for Upgraded AEGs and DMR Builds.
Smart Fuse. A combination of current, voltage and temperature measurements makes your AEG installation highly reliable. It protects the MOSFET against overheating, overloading and short-circuiting. If your AEG becomes jammed, the function protects the motor and battery against damage.
Self Diagnostics that allow you to quickly check whether the AEG Controller works properly. If you have problems with your AEG, the BUILT-IN SELF-TEST allows you to check that the problem is not caused by the Controller.
Whats in the Box:
GATE Electronics NanoHARD
Additional kit of Deans-T Connectors
Single signal wire for trigger contacts
Double signal wire for trigger contacts
Programming button
Jumper (2pcs.)
